[En-Nut-Discussion] Ethernut 1.3H External RAM problem

[Ole Reinhardt]

Hi

> I have post this problem before but I didn't fix it yet, here is the update,
> 
> Recently I repalced the SRAM K6X0808C1D-BF55, with K6X0808C1D-BF70, but it
> doesn't work, I don't know what I have to do to test it, what I have to
> check, I tried the SRAM test of Basemon, it give me an error message"No RAM
> at 0x8000", I read the MCUCR, & XMCRA registers, it was zero both of them,
> what dose it mean?

If I remember you said, that you destroyed your board by overvoltage and
then replaced the chips, right?

Have you ever thought about replacing the CPU as well? Perhaps some
lines of the data / address bus are not working any more?

Bye,

Ole

-- 

Thermotemp GmbH, Embedded-IT

Embedded Hard-/ Software and Open Source Development, 
Integration and Consulting

http://www.embedded-it.de

Geschäftsstelle Siegen - Steinstraße 67 - D-57072 Siegen - 
tel +49 (0)271 5513597, +49 (0)271-73681 - fax +49 (0)271 736 97

Hauptsitz - Hademarscher Weg 7 - 13503 Berlin
Tel +49 (0)30 4315205 - Fax +49 (0)30 43665002
Geschäftsführer: Jörg Friedrichs, Ole Reinhardt
Handelsregister Berlin Charlottenburg HRB 45978 UstID DE 156329280