[En-Nut-Discussion] Nut/OS under Ubuntu 14.04

[Uwe Bonnes]

>>>>> "Michael" == Michael H <farwest at gmx.de> writes:

    Michael> Am 23.11.2014 um 15:37 schrieb Uwe Bonnes:
    >>>>>>> "Michael" == Michael H <farwest at gmx.de> writes:
    >> 
    Michael> [..]
    >> 
    >> You still didn't tell what conf file you used... If it is not in the
    >> distribution, make it available...
    Michael> I do not use a special configuration. I unpack a fresh
    Michael> ethernut-5.1.0-1.tar.gz, change into the created folder, do
    Michael> './configure' which runs ok. Then I do nutsetup like this:

    Michael> './nutsetup' Select a target device:

Okay,

I tested nutsetup and that seems totally broken.

Is your board similar to one of the boards listed in nut/conf/*cfg.
You can use nutconfigure on the command line to create a build
environment. I have bash scripts for that. Or call qnutconf with that
XXX.cfg file and run graphically.

I will try to have a look at nutsetup.

Bye
-- 
Uwe Bonnes                bon at elektron.ikp.physik.tu-darmstadt.de

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------